2022 Free Updated CCNP Data Center 350-601 DCCOR Dumps Questions

2022 Free Updated CCNP Data Center 350-601 DCCOR Dumps Questions

You must pass the CCNP Data Center 350-601 test if you want to obtain CCNP Data Center certification and further your networking profession. FreeTestShare updated CCNP Data Center 350-601 DCCOR Dumps contain actual CCNP Data Center questions and answers that have been verified and updated to ensure accuracy. FreeTestShare provides a free CCNP Data Center 350-601 demo with real exam questions and answers to assist you to understand the exam topics and format.

Page 1 of 4

1. An engineer is implementing NPV mode on a Cisco MDS 9000 Series Switch .

Which action must be taken?

2. Refer to the exhibit.

What is the result of this series of commands?

3. Refer to the exhibit.

An engineer must distribute all the host ports to use all eight configured FEX uplinks. The solution must minimize disruption if an uplink fails.

Which action accomplishes this objective?

4. An engineer updated firmware on Fabric Interconnects and activates it. However, the endpoint fails to boot from the new firmware image .

What is expected to occur in this case?

5. Refer to the exhibit.

An engineer needs to implement streaming telemetry on a cisco MDS 9000 series switch. The requirement is for the show command data to be collected every 30 seconds and sent to receivers .

Which command must be added to the configuration meet this requirement?

6. Which data structure results from running this Python code?

7. Which two authentication types does Cisco UCS Manager support when configuration authentication? (Choose two.)

8. Multiple roles are applied to a user on the Cisco MDS 9000 Series Switch .

Which statement is true?

9. Which method must a network engineer use to upgrade the BIOS firmware of a Cisco UCS standalone C-Series reck-mount server?

10. An engineer must configure HTTPS secure management for Cisco UCS Manager using a key ring named kr2016 and a key size of 1024 bits. The environment consists of a primary fabric interconnect named UCS-A and a secondary fabric interconnect named UCS-B .

Which command sequence must be used to accomplish this goal?


Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *