Delta – Building HPE Hybrid IT Solutions HPE0-V15 Exam Questions

Delta – Building HPE Hybrid IT Solutions HPE0-V15 Exam Questions

Delta – Building HPE Hybrid IT Solutions HPE0-V15 Exam Questions are newly cracked for your best preparation, it validates a successful candidate has foundational knowledge and skills of the HPE infrastructure strategy, encompassing SMB server, storage, networking, and management tools and their underlying architecture technologies. You will surely pass your HPE0-V15 exam successfully after studying Delta – Building HPE Hybrid IT Solutions HPE0-V15 Exam Questions.

Try free HPE0-V15 practice exam online.

Page 1 of 2

1. Refer to the exhibit.

You are validating a Nimble HF40 configuration created in OCA, and you receive an error when you run a CLIC check.

Which Nimble component needs to be added to the configuration to complete the solution?

2. Read the question, and then refer to the exhibit.

<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP>

An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.

The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.

What must you do to resolve this issue?

3. A customer is moving a server from a co-location facility back into their existing data center to comply with new internal policies on data management

Due to budget constraints, the customer cannot purchase any additional switches and will need to use an existing end-of-row design with HPE FlexFabric switches While the server will be installed six racks away from the switches, the total cable run with cable management Is expected to be 35 m.

Which component should be selected when designing the 10 Gbps connectivity option for the server?

4. A customer requires five HPE ProLiant servers that will be mounted in a rack and shipped from site to site All servers must be online within an hour of site arrival

Which feature will ensure that the servers will be available to the business if travel motion has damaged a DIMM?

5. Refer to the exhibits.

A customer is growing rapidly, and they need to add as many drives as possible to their MSA 2052 array. You created the original configuration.

How many drives can be added to the customer array? (Select two)

6. You are discussing storage types with a customer that is configuring their NAS solution.

The company's application developers use user-generated media and image files.

For which type of data should this customer use file storage?

7. A customer requires a management solution that will provide email notifications if hardware errors occur on their servers.

Which management solution provides this functionality?


Match the customer requirement to the appropriate HPE storage solution.

9. A customer is subject to regulatory requirements and their data is highly sensitive.

Which HPE Smart Array feature addresses their need for an level of security for data stored inside their server?

10. A customer has a small business office and is concerned that the local storage in their current ProLiant Gen 10 server with a Linux OS Is reaching maximum capacity

Which solution should you recommend to expand the customer’s data storage capacity?


Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *